The pressure sensor can be installed in the nozzle of the injection molding machine, the hot runner system, the cold runner system and the cavity of the mold. I...
Nowadays, in the face of increasingly fierce market competition, extensive factory management has been seriously out of date. The quality of factory management ...
The residual stress is too high. When the residual stress in the plastic part is higher than the elastic limit of the resin, cracks and cracks occur on the su...
1) The fuel tank volume is too small, the heat dissipation area is not enough, and the cooling device has a small capacity.
2) The dosing pump oil supply sys...
Chinese
